HGS-2521

The low-frequency speaker HGS-2521 is built in full compliance with the principles of uncompromising SQ subwoofers - a combination of a strong "motor" and a lightweight cone from a rigid cellulose composite. Powerful die cast frame (basket) eliminates any possibility of parasitic sounds appearance, even in extreme usage modes of the speaker.

The frame of the voice coil is made of black aluminum, which gives additional heat dissipation and avoids the effect of temperature compression - short-term increases in the active impedance of the voice coil winding at the signal peaks and as a consequence, narrowing the dynamic range.

The speaker’s motor, surround and spider are provide a linear movement of the cone within 24 mm with a soft restriction when exiting beyond the operating conditions. This minimizes distortion at normal and at high volume levels and eliminates the possibility of mechanical damage to the speaker when operating in extreme usage modes.

The motor uses ferrite magnets of the highest grade with excellent stability and repeatability of it’s parameters. When you install the speaker in the recommended acoustic enclosure, you get a subwoofer with a fast and accurate response to the signal being transmitted, capable of transmitting not just the power and depth of the bass, but also draw perfect structure of complex bass instruments and can show all the beauty of the bass range.

The speaker`s ability to work in compact acoustics enclosures and installation depth of only 136 mm makes the HGS-2521 an ideal choice not only for installation in a classic enclosures, but also in stealth-enclosures when free space is limited. The optimal power of amplifiers for working with HGS-2521 is around 300-600 Watts.

Specifications
ModelHGS-2521
Size10 Inch
SurroundRubber
ConePressed paper
FrameAluminium
Magnet typeFerrite
RMS Power230 W
MAX Power450 W
Voice coil size2.00 Inch
Voice coil wireCCA
SpiderNomex
Impedance4 Ohm
Re3.8 Ohm
SPL84.15 dB
Xmax10.00 mm
Fs30.78 Hz
Vas23.00 L
Qts0.31
Bl17.64
Newsletter